环境监测用氮气中多组分VOCs标准物质的研制

介绍了采用称量法制备瓶装1μmol/mol氮气中42个组分挥发性有机物(VOCs)标准物质的研制方法。建立了选择离子模式,气相色谱-质谱联用的分析方法,对目标组分在气瓶中的长期稳定性进行了考察。所选择的42种目标组分完全满足中国环境保护标准《环境空气挥发性有机物的测定吸附管采样-热脱附/气相色谱-质谱法》(HJ 644—2013)和美国环保署《使用特殊处理的采样罐/气相色谱仪检测环境大气中的挥发性有机物》(EPA TO—14A)这2个方法标准中所规定的环境空气中挥发性有机有害成分的监测要求。将研制的气体标准物质与中国计量科学研究院(NIM)和英国国家物理实验室(NPL)分别进行了比对测试,取得了良好的比对结果与国际等效度。结果表明,1μmol/mol氮气中42种组分VOCs标准物质的有效期为一年,相对扩展不确定度为5.0%(包含因子k=2),并取得国家标准物质证书GBW(E)062231。     

Proposing of new building scheme and composite towards global warming mitigation for Malaysia

The building sector has been regarded as a potential sector where there is large capacity to reduce the climate change effect. This study has proposed solutions to mitigate environmental impacts and achieve low CO₂ emission from residential sector. Therefore, full life cycle assessment (LCA) has been run to assess the CO₂ emission and its effect on the atmosphere and climate change. Based on the result, timber scheme is the best choice due to releasing less CO₂ emissions to the atmosphere. However, house builders in Malaysia have almost completely neglected timber as a building material, with timber use as building components reduced to 5%. In this study, LCA Software was used to assess CO₂ emissions from different wall construction. The alternative building scheme has been made by reinforce steel stud, wooden beam and timber wall (S8) to improve the scheme deficiency while releasing less CO₂ emissions compared to other schemes. Therefore, S8 has a decreased CO₂ effect by 85% less than precast concrete frame and 90% less than brick over their lifetime. (S8) increased the load bearing compared to conventional timber beam. Thus, new scheme S8 could be replaced by current scheme and promote more adjustable scheme for Malaysian housing.     

新制备生物炭的特性表征及其对石油烃污染土壤的吸附效果

生物炭作为一种绿色环保的功能材料因其在污水处理和污染土壤修复方面具有显著效果而受到极大关注.采用红外光谱、元素分析仪及微孔分析对不同温度(200、300、400、500和600℃)条件下制备的木屑和麦秆生物炭进行特性表征,并采用制备的生物炭净化石油污染土壤,分别考察了污染物性质、生物质原料和热解温度对其净化效果的影响.结果表明,随着热解温度的增高,生物炭芳香化程度增加,极性降低,微孔结构逐渐发育,表面积增大.加入生物炭33 d后,污染土壤中总石油烃及其组分烷烃的浓度比对照略有降低,而PAHs浓度下降显著.随着热解温度升高,2种生物炭对PAHs的吸附强度均逐渐增大,芳香度增高、表面积增大是强吸附的主要原因.2种生物炭在400℃及以下温度制备时对PAHs的吸附强度为:木屑生物炭＞麦秆生物炭;而400℃以上温度制备的生物炭吸附强度则相反,即麦秆生物炭＞木屑生物炭,说明生物炭原料对其吸附强度也具有显著影响.     

一种导电混凝土的制备及其电阻率测量

本文综述了导电混凝土的发展以及应用情况，提出了用导电混凝土作为接地材料的设想，并选择氧化铁粉作为骨料，添加适量碳粉配制了一种导电混凝土来验证。通过改变不同的配比制作导电混凝土模型，用四电极法测量其电阻率，得出碳粉比例对其电阻率的影响。     

不同暴露途径下有机污染物对大鼠急性毒性的相关性研究

不同暴露途径下有机物在生物体内的吸收分布不同,导致毒性效应亦不同,研究化学品在不同暴露途径下对生物体的毒性,对化学品的安全性评价有实际意义。本文通过研究静脉注射、腹腔注射、肌肉注射与经口灌胃4种暴露途径下527个有机物对大鼠的急性毒性数据相关性,比较了不同暴露途径下大鼠对有机污染物的敏感度顺序,结果为:静脉注射>腹腔注射>肌肉注射>经口灌胃途径,静脉注射途径下log1/LD50与其他几种注射途径下的log1/LD50有较显著的相关性,但是与灌胃途径下毒性值之间的相关性较差,相关系数r的范围为0.82~0.97。通过逐项分析研究不同暴露途径下化合物对大鼠的急性毒性与生物利用度、吸收速率、消除速率以及代谢过程的关系,结果表明,导致这种差异的原因主要是有机污染物在大鼠体内的吸附动力学过程不同所致。     

A transportation network assessment tool for hazardous material cargo routing: Weighing exposure health risks,proximity to vulnerable areas,delay costs and trucking expenses

The inherent risks associated with accidental releases of hazardous materials during transport have drawn attention and concerns in the recent decades. The aim of this study is to propose a tool for evaluation and comparison of the transportation networks which can be used to assess the routing options between origins and destinations of the cargos for their suitability for transporting hazardous material cargos by tanker trucks and to identify routes which provide lower accidental release risks, lower public exposure risks, and offer economical benefits. Each route segment of transportation networks were evaluated using specific criteria which included health risk and cost of delay in case of an accidental release of materials, trucking cost and proximity to vulnerable areas. Since, the health impact of hazardous materials differ depending on the characteristics of the material being transported as well as release quantities and atmospheric conditions; this paper aimed in providing a tool that can be used to estimate the impact radius (for health risks) after accidental release of hazardous materials by taking into account different atmospheric conditions based on the meteorological data and solar elevation angle. The Gaussian air dispersion model paired with ArcGIS using Python programming were employed to estimate the health risk impact zones by considering the meteorological data, and accordingly to analyze road segments for cost impacts (delay and trucking costs), and the proximity to vulnerable areas. The route assessment tool was demonstrated with a case study. The results of this study can efficiently aid decision makers for transportation of hazardous materials.     

金属材料海水腐蚀试验方法的编制及标准解读

为了使相关人员更好地理解标准,更好地完成试验,回顾了我国金属材料海水腐蚀试验方法和标准的编制历程,对金属材料海水腐蚀试验的两个现行国家标准进行了解读和比较。     

过硫酸盐缓释材料释放过程模型构建

为预测评估过硫酸盐缓释材料的释放性能,对释放过程模型的构建以及模型的验证进行了研究。借助微积分思想,从材料体的概化分割、初始条件设定、每个小单元的状态标定、各个小单元中过硫酸钾的迁移变化量以及材料最外层释放过硫酸盐的量5个方面构建过硫酸盐缓释材料释放模型,利用Excel-VBA编程实现其释放过程模拟。采用欧盟标准NEN7375测试过硫酸盐缓释材料释放性能并获得模型参数。通过输入相关模型参数得到过硫酸盐动态迁移过程及其释放特征曲线,并利用实测数据与模拟数据进行拟合校验。结果表明,模型模拟值与实测值拟合较好,平均误差为1.88%,表明该模型设计合理,能够准确模拟过硫酸盐缓释材料释放过程,可作为缓释材料优化设计工具。     

清洁生产审核中物料平衡的难点及应用实例

建立物料平衡是清洁生产审核第3阶段（即“审核”阶段）最核心的工作内容,其目的是为了准确分析物料流失和废物产生的原因,建立物料平衡也是产生清洁生产方案（尤其是中高费方案）最主要的方法之一。本文在介绍清洁生产审核中物料平衡的完整工作步骤的基础上,归纳了几点在实际工作中应用物料平衡遇到的难点及要点,实例介绍了物料平衡、能源平衡和水平衡三种常用平衡,为审核工作者提供些许思路参考。